To set your printer as the default in Windows NT 4.0:ġ Click Start on the taskbar, click Settings, and then click Printers.Ģ Right-click the HP DeskJet 690C Series Printer icon and choose Set As Default.Ĭommunications test and two-way communications In Windows 95, Windows 98, and Windows NT 4.0:ġ Right-click the software program on the taskbar and click Close.Ģ Repeat step 1 for each open software program. To ensure successful installation of the printer software:ġ Make sure your computer is fully set up and operational.Ģ Check that the printer is properly set up and ready to print using the instructions in this setup guide.ģ Make sure that the printer is connected directly to the computer (remove any switch boxes or other devices using the same port) and check that all cable connections are firm.Ĥ Make sure the computer and the printer are turned on.ĥ Close any virus protection programs or other software programs that are running on your computer (see page 13 for instructions).īeginning on page 9, follow the installation instructions for the operating system on your computer.Īdditional information about installing your printer softwareġ While holding down ALT, press TAB to locate an open software program.Ģ When you locate an open software program, release both keys.Ĥ Repeat steps 1 through 3 for each open software program.

If your computer does not have a CD-ROM drive and disks were not included with your printer, see page 49 in the userÕs guide for information on obtaining printer software. HP recommends that you install from the CD.

Before you can use your new HP DeskJet printer, you must install the printer software.

Hp deskjet 940c ink light flashing